Schwinnstingray1964
New Member
- Joined
- May 12, 2009
- Messages
- 307
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1992
- Make / Model
- Ranger XLT
- Engine Size
- 2.3 4Cyl
- Transmission
- Manual
About a Year ago, The clutch pedal on my 92 had sunk all the way to floor.
I put in a new master cylinder, and the pedal came back up.
1st question, The hose that goes to the slave, Is it supposed to have an o-ring on it? Does anyone have a picture of said o-ring.
2nd question, Where is the bleeder valve on the trans.
3rd question, How hard is this whole bleeding thing to do? Would i be better off sending it to the shop for bleeding?
-Thanks. Schwinny.
I put in a new master cylinder, and the pedal came back up.
1st question, The hose that goes to the slave, Is it supposed to have an o-ring on it? Does anyone have a picture of said o-ring.
2nd question, Where is the bleeder valve on the trans.
3rd question, How hard is this whole bleeding thing to do? Would i be better off sending it to the shop for bleeding?
-Thanks. Schwinny.