Curious Hound
Formerly EricBphoto
TRS Event Staff
TRS Forum Moderator
Supporting Member
U.S. Military - Veteran
TRS 20th Anniversary
VAGABOND
TRS Event Participant
GMRS Radio License
TRS 25th Anniversary
- Joined
- Feb 7, 2016
- Messages
- 18,152
- Age
- 61
- City
- Wellford, SC
- State - Country
- SC - USA
- Other
- 2002 F250, 2022 KLR 650
- Vehicle Year
- 1993
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 3.0 V6
- Transmission
- Manual
- Total Lift
- 6"
- Tire Size
- 35"
- My credo
- In theory, theory and practice are the same. In practice, they are different.
And not as much fun...
Recently, I've been hearing a ticking noise during left-hand turns. So I jacked up the driver side axle beam, turned the wheels left and rotated it. Didn't hear or feel.anything odd. Then I wiggled the top of the wheel in and out. Ah-ha! A little bit of play. With the 35" tires, I sometimes don't torque the bearing nuts quite enough. I would rather have them a little loose than too tight. But these take "just a bit more" than recommended torque. No problem. I zipped the wheel off so I could tighten the nuts. Removed the hub and found a broken o-ring seal and brown/black grease that was red when I put it in there.
Ok. It's late and I'm not ready for that job. We'll do the bearing clean and pack job next week. I'm working tomorrow and through the holiday weekend. 12hr shifts.
Recently, I've been hearing a ticking noise during left-hand turns. So I jacked up the driver side axle beam, turned the wheels left and rotated it. Didn't hear or feel.anything odd. Then I wiggled the top of the wheel in and out. Ah-ha! A little bit of play. With the 35" tires, I sometimes don't torque the bearing nuts quite enough. I would rather have them a little loose than too tight. But these take "just a bit more" than recommended torque. No problem. I zipped the wheel off so I could tighten the nuts. Removed the hub and found a broken o-ring seal and brown/black grease that was red when I put it in there.
Ok. It's late and I'm not ready for that job. We'll do the bearing clean and pack job next week. I'm working tomorrow and through the holiday weekend. 12hr shifts.