3.0 Timing Help

[eloyc]

Any chance you set #1 to TDC exhaust? Regardless you should get some pops and bangs. You sure the injectors are firing? If you pull a plug after trying to start it, is it wet with gas? Have you tried spraying some flammable liquid into the throttle body to see if you get anything then?

Yes I've tried all that and still nothing. Checked for spark multiple ways, tested injector wiring with test noid, I did another cold compression test, all spark plugs out and got about 130ish on each cylinder. I might not be getting fuel pressure so checking that next.

 

[Silas Mc]

Any chance you set #1 to TDC exhaust? Regardless you should get some pops and bangs. You sure the injectors are firing? If you pull a plug after trying to start it, is it wet with gas? Have you tried spraying some flammable liquid into the throttle body to see if you get anything then?

I second that. I would try a little starter fluid. Then at least you could narrow it down.

 

[RobWigglezz]

Yes I've tried all that and still nothing. Checked for spark multiple ways, tested injector wiring with test noid, I did another cold compression test, all spark plugs out and got about 130ish on each cylinder. I might not be getting fuel pressure so checking that next.

One of your earlier posts said you pushed the Schrader valve on the fuel rail and it flowed out. It should do more than just flow out. It should spray out pretty good if you just turned the key making the fuel pump prime.

A quick spritz of starting fluid into the throttle body will give you a clue.

 

[eloyc]

One of your earlier posts said you pushed the Schrader valve on the fuel rail and it flowed out. It should do more than just flow out. It should spray out pretty good if you just turned the key making the fuel pump prime.

A quick spritz of starting fluid into the throttle body will give you a clue.

I did some sprays and nothing happened, there was no change. It just kept cranking normaly

 

[RobWigglezz]

I did some sprays and nothing happened, there was no change. It just kept cranking normaly

If you had spark and a mis timed engine, starter fluid should make it have an uneven crank because its firing and working against itself as well as a few pops.

Maybe your plugs loose spark when threaded into the heads? Did you double/triple check all your grounds are connected to the firewall, block, and heads?

 

[eloyc]

Yes, everything is connected