- Joined
- Aug 15, 2019
- Messages
- 4,005
- Reaction score
- 1,986
- Points
- 113
- Location
- Oklahoma
- Vehicle Year
- 1993
- Make / Model
- Ford Ranger
- Engine Type
- 4.0 V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
I have a M50D transmission from a rebuilder, that's had numerous flaws in it, but it's in the truck and I started it and shifted it through the gears(drive shaft not installed) and it seemed to be working ok in that mode, trouble is I can't get the transfer case to pull on it. It's been a slow go getting it most of the way, but it just won't pull in tight. I've got it this far by turning each bolt bit by bit, but it's to a point now I'm worried about breaking something, namely one of the bolt lobes on the transmission
Anybody ever had this problem??
Any ideas?
Anybody ever had this problem??
Any ideas?