bronco ii

Hello! I swapped out my 4x4 transfer case motor on my 1990 Bronco II XLT and I now have no lights at the dash at all and zero control module actuation. Before the swap the lights would come on for both 4 Hi and 4 Lo and the you could hear the 4x4 control module function. Now there is zero...

What is this opening on my 2.9? I got down there to clean and change the oil sender unit and noticed there's a deeply recessed port. Not sure if it's the norm and I'm just overreacting but I don't want to run to pick n pull to check without asking first. Any clue what this is and if there should...

Have some connectors unplugged with no wires dangling for an idea what they are. One is in the engine compartment next to the harness with light blue wires. Appears to go to VSS based on a manual 89 so I grabbed that cable but mine has dark green/white and orange wires on its vss connector with...

Hey there all!!! I've officially searched through this site, FTE, and even explorer forums(posted this on there too) but still can't find a straight answer as to a possible problem with my trans. Here is what I changed: Transtec valve body gaskets. Transgo and Superior Shift kit combined. Sonnax...

Hi, I’ve got a 1988 Ford bronco ii. It’s running like sh*t. I’m not sure exactly where I’m at with it. As in I’m not sure if any of the new parts I’ve put in are marking the problem worse, or if the bad part is getting worse over time. The spark from the coil to the distributor seems ok. The...

Ok so I have no revers lights in my Bronco II - A4LD trans and 4x4. I first replaced the NSS thnking that was the issue - still no lights. Also its starting in all gear positions now. Will get to that later.... As far as the light issue goes - I Tested Purple/Orange wire in harness and have...

Hi, I've got a 1987 Bronco II. It's a 2 wheel drive. It runs and drives well. When I bought the truck. It had a pretty bad grinding noise when I would go from stop at a red light to take off. I figured it was either sticking brakes or the transmission. I checked the brakes, but they looked ok. I...

Hi guys, new heads on a 1986 2.9L Bronco 2. The new injectors on the passenger side don't seem to sit as far down as the drivers side. We unbolted and rebolted the fuel rail a few times and we can't seem to get the passenger side injectors to go down any lower with or without the fuel rail being...

I'm looking for Sway Bar Links that are compatible with a 1990 Ford Bronco II with a 6in. Lift any suggestions? Thank you

Is there a difference between 1989 & 1990 Bronco II hard lines? Conducting a brake job that is becoming a restoration project... The only preformed lined are up to 88 & 90 w/abs. Advice and input is very much appreciated at this point. Thanks in advance.

Hey guys, so since my last post, I got my 2.9 put back together, in the truck, and it's running like a champ, purring like a kitten. You see the only issue that I'm having, which as I understand, is a 2.9 "thing" is that my idle won't go down no matter what I do to it. If I start the truck and...

Hello! I'm pretty new here, so I hope I'm posting in the correct thread. TLDR: A4ld went out, want to find a M5OD to swap in. Skip to the "CONCLUSION" if you don't want the full story. I was given a 1990 Bronco II by my Grandpa, it's sort of been a family vehicle for a long time. I drove it...

Well my problems came back after running good for a month, My 1988 bronco ii 5 speed had a loose ground causing it to buck and surge. Well this month my bronco ii started running worse then ever it would start missing and would idle low at a stop sign then finally come to a complete stall. It...

Hello ranger station i recently bought a 1988 bronco ii 2.9 5 speed that had been running like crap, My issue is when warm my truck idle surges at around 400-550 sometimes if i give it throttle it will go back to 900. (this sucks when driving in town and stop and go traffic on hills) it feels...

An introduction to me and my second recently acquired Bronco II- I might have found the greatest deal on any Bronco II, ever. It was purchased in 1990 to be towed behind and RV, and only got about 50,000 of actual road time before I got it a few days ago for $350... with 157k on the odo. It...

So I've been a fan of the Bronco II since the 80's. A 1984 Manual 4x4 was the first car I owned in high school (Blue on Blue). Then in the mid 90's I ended up purchasing an amazing 88 (Grey on Blue) XLT which was my baby. I owned it for 10 years and with life and adding a child into the mix I...

Hey all. I just replaced the fuel tank, pump and sending unit on my 1990 Bronco ii and can't seem to get it running again. Before replacing the tank and all that I did a full tune-up and replaced the map sensor and tps. I made sure everything was square and the truck was running well before...

I'd like to start off by saying I'm new to this whole scene, this is my first vehicle and I didn't know a thing about mechanics or trucks 2 months ago (so don't judge my noobness :icon_thumby: ). I have this 89 b2 that I'm looking to do some mods/upgrades on. Basically I wanna beef this guy up...

I'm going to get to the point and before anyone asks "why on earth..." I have included the reasons below. I want to put a non-Ranger truck cab on my B2 so I can seal the passenger compartment back up and pass an inspection (will be registering the vehicle off the cab's title so it's a truck...

I've got a 1990 Ford Bronco 2 4x4, and I'd like to lower it. As far as I know, no one has done this, so when I google ways to do it, I only get ways to lift it. I was thinking about using lowering springs, but I don't know enough about them to do that. Also, since I'm on a budget, bags aren't an...