What did you do to your Ranger today? (Part Deux!)

[Rick W]

My bad. I just took mine apart to refamiliarize myself. Hang on a sec. I'll figure out a procedure.

I appreciate it, and do it if you’re curious, but I’m sure I can figure it out

 

[Curious Hound]

I'm not sure if this is helpful or not. But I won't charge you for it. Accidentally recorded it in slow-mo and had to do extra editing.

 

[85_Ranger4x4]

From the videos it looks pretty easy to reach everything without dropping the trans, even getting the pins out since you punch him from the inside out. And I bet it’s even pretty easy to slide the pin in in the space available, but I don’t see how I can apply any force to it to seat it, not much room on the outside, but I’m sure I’ll figure it out. Apparently millions have done it.

Don't force it, just get a bigger hammer.

 

[Rick W]

I'm not sure if this is helpful or not. But I won't charge you for it. Accidentally recorded it in slow-mo and had to do extra editing.

I’ve watched that a couple times already, but I’ve been so turned on by the shorts and the skin and those sandals, it’s hard to focus on the job at hand!



I made a few tools when I was trying to get the cam thing out of the 4.0 that’s buried under the upper intake, and I’m going to sketch up something just for conversation. I’m not really worrying about it until the kit comes in in a few days, and when I tear it apart

I also got the new pumpkin for the rear, the limited slip, and I may tackle that at the same time.