New System For The Old Girl

[cmcolfax]

Looks great so far!

 

[Broosedamoose]

I had to veer off the path for a little bit. Found some spots that are rotted through the floor. Cleaned them up with the needle gun and treating them with POR15. Then I’ll fiberglass over them.

 

[Broosedamoose]

OK, back on track. I got the sound deadening finished, the door panels all wired and the front speakers in. I had to trim the lip around the speaker opening on the door panel because it was hitting the adapter. I tucked the crossover up under the armrest. Fit perfectly.

I used a two-pin Deutsch type connector for the door speaker so the panel can be removed easily. It's starting to come together.

 

[Broosedamoose]

Moving slowly due to a health issue but, making progress. I finished the sound deadening. I decided to just do everything inside. I painted the radio bezel and the HVAC knobs a silver-metalic that is close to stock but with no gray. I put an LED in the radio bezel just above where the HVAC knobs will be. I have yet to install LED's in the driver and passenger footwells as courtesy lights and an LED in the glove box connected to a micro switch. I also decided to put in a new carpet. Then I can start putting it all back together!