Looking for someone to cut dxf files using my steel ohio

[powerstrokekid]

Hey everyone I recently purchased dxf cut files for a Dana 44ttb truss, and I also have a 4x6’ sheet of 1/4” steel at home. I was wondering if anyone has a plasma table and would be willing to use my steel to keep cost down. You’re welcome to copy’s of the files. I’m located in new London Ohio and travel to Cleveland daily. Thank you.

 

[Blmpkn]

My local metal supplier offers a plasma table service... perhaps call around and see if any of your local places do the same.

 

[Shran]

You might try over on the Langmuir forum - https://forum.langmuirsystems.com/ or their facebook page

That is almost exclusively DIY folks from all over the country. Maybe there is someone local to you. I'd do it if I was closer.