93 Splash in SC, V8-Swap version

[Curious Hound]

Decided to work on the instrument cluster/screen thingy. I was originally going to design a piece to be 3D printed that would hold the screen, it's remote USB ports and my OBD II port. But it was difficult to get accurate measurements for the mounting points. I might still do that one day. But, I remembered that I had this aluminum/plastic/aluminum sandwich material that worked so well for my custom visors. So, I made the mounting plate out of that. It's not petfect. But it's a good, snug fit and will look good with the trim bezel put back in place. Warning; NOTHING is symmetrical about this space and the way the gauge cluster mounts. Do not assume symmetry anywhere.

 

[Curious Hound]

After the rain, I went back out and worked on removing obsolete wiring. I got the rest of the transfer case controller wiring removed. Also started removing the RABS module. There's not a lot to remove and I'm not pulling the dash for complete access. So, some dead-end wires will remain in place. But I want to get as much out as possible to clean things up. A few things may get re-purposed. Plus, I need to sort out the gauge cluster wiring and prepare whatever will be re-used with the digital dash package.

 

[SenorNoob]

...Warning; NOTHING is symmetrical about this space...

That would be an accurate description of my house.