mosdef
New Member
- Joined
- Jun 13, 2015
- Messages
- 1
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 2005
- Make / Model
- ford ranger
- Transmission
- Automatic
Hi, I am swapping out a trans on my 05 fx4 ranger. The new one came with a torque converter but I left the old one in. I can't get the trans to seat properly, I can get all the bolts in but there is still about a 3/8 inch gap, the dowels are lined up but aren't going in. I was thinking the splines on the input shaft weren't lined up with the torque but if that was the case i think the gap would be bigger. I had to leave the Y-pipe on so I really don't want to pull the trans off again because it was a bitch to maneuver it in there in the first place.
Has anyone encountered this problem? Any help would be greatly appreciated!
Has anyone encountered this problem? Any help would be greatly appreciated!