New guy New project

[tailgate_mafia]

Hey everyone I'm new to the site. Ok I have owned 2 rangers before but they were 2x4 now i have a 1994 ranger stx. after rebuilding the top end of the 4.0 and putting new leaf hangers and shackles on it i'm putting a 3" b/L on it. i has 31x10.50 R15's now how can i get another two inches of suspension lift with buying a pricy kit? Also for off roading where would be the best place to place the exhaust tip? and finally how hard is it to charge the pilot bearing?

 

[lethal-threat-b288]

rough country sells a 3 inch kit for 500... has all nessecary hardware for it.

 

[tailgate_mafia]

Well i put the body lift on lastnight but i herd i could mess with the torq bar to gain 2+ inches in the front and i could use lift blocks in the rear

 

[StephenLewis]

Your truck will have the TTB up front so you will have coil springs up front, not the torsion bars. Torsion bars are found on the 98+ A arm style 4x4 rangers and the odd ball Edge.

 

[tailgate_mafia]

Ok i see. Not quite use to 4x4 rangers just f150's

 

[lethal-threat-b288]

ttb suspention is easy to lift too.pics pics