2.3L ('83-'97) Time for a new clutch 96 2.3

[justinae]

this is a PTFE seal so I think dry is correct. the plastic install guide is a clue that they don't want you to lube it. Victor Reinz doesn't offer much in terms of instruction but their vids on front oil seals are clear about not using lube.

 

[SenorNoob]

Weird, but ok. IDK if applies here, but I've heard of putting RTV on the outer surface of a crank seal before...

 

[alwaysFlOoReD]

this is a PTFE seal so I think dry is correct. the plastic install guide is a clue that they don't want you to lube it. Victor Reinz doesn't offer much in terms of instruction but their vids on front oil seals are clear about not using lube.

Let us know how it goes. I would really like to be wrong...

 

[justinae]

I did a deep dive and found enough information that makes it really clear that PTFE seals go in dry. Here's a short explainer vid. For the record I read official manufacture docs, not some randome YT guy but this does explain it.

 

[justinae]

Ok guys. I've got the new seal seated square and just need to pound it in. It "appears" that it's too wide. When i get a tiny bit in with fingers and try to get the opposite side in just a smidge it won't go. I know I can't do the whole thing with fingers but I'd like to at least get the metal lip in with fingers first.

any ideas?