Spindle shaft seal part numbers

[steppinthrax]

Hey guys, I have a 97 Ranger 4WD and I've been rebuilding the passenger side of my front end. I'm trying to find comprible replacement spindle seal. This is the seal that rides along the front drive axle and butts up agasint the spindle. I believe it's a dust seal, I've searched the numbers and I'm getting all different type of parts from National, Timken etc, a post from here also appears when I search FORSHEDA 10.054, but it's for DANA 44 while I have a DANA 35, while I understand they share simlar parts. Just need confirmation.

 

[pjtoledo]

try this site. I did not go into it.

Spicer Media Literature Library | Spicer Parts

The Dana Aftermarket Media Library is your centralized hub for product information, offering easy access to brochures, part catalogs, technical bulletins, service manuals, and a wide range of additional resources. Light Vehicle and Commercial Vehicle Browse Dana Aftermarket Media Library

spicerparts.com

 

[lil_Blue_Ford]

SBK4 is the part number for the part set from Autozone. Has the dust seal, spindle seal, and a new needle bearing for the spindle

 

[SenorNoob]

I was gonna say, it's far easier to get it together like that.^

If you don't, it's possible to get a stack of parts that don't fit together. BTDT

 

[steppinthrax]

SBK4 is the part number for the part set from Autozone. Has the dust
seal, spindle seal, and a new needle bearing for the spindle

Can you tell me what any of this is. I see the needle bearing and I understand that's inside the spindle. But that larger on seal on the bottom left doesn't seem to match, the lip also seems at an angle? What are those other parts go to? Do they go behind the needle bearing? I haven't taken my needle bearing out. I've been keeping it in there and I've moved it with my fingers and it seems to be good, however, I'm not against replacing it.