Need help

[DavidWalter]

I have Mazda B3000 truck 4x4 (same as Ranger) putting ball joints in had pull front axle out passenger side right side I desperately need diagram showing were the dust seals and grease goes on axle and spindle in detail better still names and part numbers.

 

[Curious Hound]

Like this?

https://www.therangerstation.com/tech_library/pdf_documents/Dana_Ford_35.pdf

 

[DavidWalter]

I have Mazda B3000 truck 4x4 (same as Ranger) putting ball joints in had pull front axle out passenger side right side I desperately need diagram showing were the dust seals and grease goes on axle and spindle in detail better still names and part numbers.

Can't get top ballpoint to come through straight got little bit angle when come through is this normal?

 

[DavidWalter]

Can't get top ballpoint to come through straight got little bit angle when come through is this normal?

Balljoint

I have Mazda B3000 truck 4x4 (same as Ranger) putting ball joints in had pull front axle out passenger side right side I desperately need diagram showing were the dust seals and grease goes on axle and spindle in detail better still names and part numbers.

 

[DavidWalter]

I have Mazda B3000 truck 4x4 (same as Ranger) putting ball joints in had pull front axle out passenger side right side I desperately need diagram showing were the dust seals and grease goes on axle and spindle in detail better still names and part numbers.

Can't get top ballpoint to come through straight got little bit angle when come through is this normal?

sorry Ball joint

 

[sgtsandman]

Are you using a jack to push up the lower control arm? If not, you are never going to get it in the knuckle. You need to bring the knuckle to the upper control arm, not the control arm to the knuckle.

if you have the spindle angle of the ball joint close, nature will take it's course on the rest.