2.3L ('83-'97) Engine dies when slowing down


Featured Build Threads

Joined
Aug 25, 2025
Messages
4
Points
1
City
San diego
State - Country
CA - USA
Vehicle Year
1989
Vehicle
Ford Ranger
Drive
4WD
Engine
2.3L
Transmission
Manual
Total Lift
3
Tire Size
31
I have a 89 4x4 manual transmission that dies when slowing down especially when releasing the clutch and going into neutral. I’ve replaced the crankshaft position sensor and egr & ICM so far. Engine idles perfect and runs perfect. when engine dies it is quick, no choking or feeling of lack of fuel or air. I’m stumped. Help.
 
Last edited:
Hows your IAC valve?
 
I second that, idle air control is likely the culprit and would be the first place I would look
 
Ok I believe I replaced that about a year or two before this issue started happening but I could replace it again 👍 I’ll try it.
 
Buy a Motorcraft or Hitachi brand. Other brands don’t work as well with our Rangers.
 
Replaced the IAC valve, no change. Still dies 🫤
 
Once warmed up and running in neutral, unplug the IAC and see if the engine still runs, if you have a tach it should be running around 500rpm, if it stalls screw in the stop screw a little bit at a time.
 
Tried it, I have no tach but engine still ran after disconnecting.
 

Upcoming TRS Events

Sponsored Ad

Featured Ranger Based Vehicle

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Back
Top