Welcome Visitor! Please take a few seconds and - Joined
- Dec 27, 2025
- Messages
- 1
- Points
- 1
- City
- Edmond
- State - Country
- OK - USA
- Vehicle Year
- 1998
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 3.0 V6
- Transmission
- Manual
Hey everyone! So I’m almost finished with my swap and I’m having a couple issues. The engine and trans are installed and everything is going well but I’m having issues with the wiring, I can’t find any info on how to use the 96s starter harness in my 98, and from another forum it talked about a ground wire that needed to be cut and grounded to firewall, it also talked about the alternator and I’m not sure what to do with that. Also vacuums lines, where do they go to. This is my first engine swap and I’m learning as I go. Thanks in advance. Pics are of my ranger pre swap.
