- Joined
- Aug 12, 2018
- Messages
- 1
- Points
- 501
- Vehicle Year
- 1984
- Transmission
- Manual
Good morning,
I have an 84 Ranger 2.2 that was having ignition switch issues, so I swapped the ignition switch and the cylinder end broke off in the ignition column. After getting a new lock cylinder and discovering the problem, I decided to go with a push to start system instead of pulling the entire column. Does anyone have a good wiring diagram for wiring up a push to start? Thanks!
I have an 84 Ranger 2.2 that was having ignition switch issues, so I swapped the ignition switch and the cylinder end broke off in the ignition column. After getting a new lock cylinder and discovering the problem, I decided to go with a push to start system instead of pulling the entire column. Does anyone have a good wiring diagram for wiring up a push to start? Thanks!
