4x4countryboy
New Member
- Joined
- May 31, 2013
- Messages
- 26
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1985
- Make / Model
- Ford
- Transmission
- Manual
Ok so I have no spark at my plug, I have power at my coil, and I have power at my distributor's plug....so what should I check first and how? the coil or the distributor?
the engine turns over and all of the wireing is good as are the connections (just wired everything and checked) but not getting a spark....has new cap and rotor....has a new coil HOWEVER i do not have a resistor in place at this time so could be the coil but I have not done anything with the resistor yet other than check to see if it was getting power at the plug....but it is still the old distributor....
thoughts comments and suggestions are appreciated as always!
the engine turns over and all of the wireing is good as are the connections (just wired everything and checked) but not getting a spark....has new cap and rotor....has a new coil HOWEVER i do not have a resistor in place at this time so could be the coil but I have not done anything with the resistor yet other than check to see if it was getting power at the plug....but it is still the old distributor....
thoughts comments and suggestions are appreciated as always!