9723
Active Member
- Joined
- Oct 22, 2008
- Messages
- 324
- Reaction score
- 64
- Points
- 28
- Vehicle Year
- 1997
- Make / Model
- XLT
- Engine Type
- 2.3 (4 Cylinder)
- Engine Size
- 2.3
- Transmission
- Manual
- 2WD / 4WD
- 2WD
...but this could be a leak.
This block plate that holds the input shaft seal is difficult to get any info on, but apparently it's called an "adapter", and the input shaft "main bearing retainer". It hold a bearing and some shims too. It's apparently sealed with RTV or similar compound. I don't think I want to mess with it. Hope it's not leaking, or very much.
This block plate that holds the input shaft seal is difficult to get any info on, but apparently it's called an "adapter", and the input shaft "main bearing retainer". It hold a bearing and some shims too. It's apparently sealed with RTV or similar compound. I don't think I want to mess with it. Hope it's not leaking, or very much.
Last edited: