SebassTurtle93
New Member
- Joined
- Jun 11, 2020
- Messages
- 2
- Reaction score
- 0
- Points
- 1
- Location
- California
- Vehicle Year
- 1993
- Make / Model
- Ford ranger xlt
- Transmission
- Manual
Hello there guys.....I have a 93 ranger xlt 5 speed & I have replace the ignition control module & coil packs, fuel pump & fuel fliter as well as the ignition wires & spark plugs & o2 sensor but my truck will not start.....i recently took it to the shop & they changed the crank shaft positioning sensor & the truck turn on & while I was driving it to my friends house the engine started bogging on me as if it wasnt getting any fuel but it was still running until I got to the corner of my friends house & the truck shut off on its own so I left it there & the next day I went over to start it up & it turned on but was only able to drive it down a block when it shut off on me....did any of you guys experienced this situation before & if so how did you guys fix the situation