rangerbum
New Member
- Joined
- Apr 22, 2008
- Messages
- 1,412
- Reaction score
- 30
- Points
- 0
- Age
- 32
- Location
- Kalispell, Montana
- Vehicle Year
- 85
- Make / Model
- Ford
- Engine Size
- 2.8l
- Transmission
- Manual
I have begun my swap in my b2, putting Ex D35 front, 31 spline 8.8 rear.
Its all in, just one problem. Napa told me a week ago that they'd have the Flange I need for the 8.8, and the conversion U joint. Go in today to pick them up, and they have no such thing, and can't get them either.
I'm borrowing shop space and need to be done as quickly as possible. The temp here has been around -10 to +5 degrees this week. If I need to go to the junkyard I want to know exactly what I need and be done quick.
Is there any flange that I could put on my driveshaft or my pinion flange to accept the stock u joints since nowhere here can get them? Do 93-97 rangers with 7.5 axles have the same size and number of splines on the pinion Flange?
Its all in, just one problem. Napa told me a week ago that they'd have the Flange I need for the 8.8, and the conversion U joint. Go in today to pick them up, and they have no such thing, and can't get them either.
I'm borrowing shop space and need to be done as quickly as possible. The temp here has been around -10 to +5 degrees this week. If I need to go to the junkyard I want to know exactly what I need and be done quick.
Is there any flange that I could put on my driveshaft or my pinion flange to accept the stock u joints since nowhere here can get them? Do 93-97 rangers with 7.5 axles have the same size and number of splines on the pinion Flange?