• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

transmission

  1. 1987 Ranger HELP ME

    I have a 1987 ford ranger 2.3L 4cyl Its my first truck and it needed all new head gaskets, dist cap, sparks,wires, air filt, and a few small things. i replaced all of that. i drove it for 2 months and the transmission is like: 1. Start car go in drive, moves till i let off gas and then i...
  2. transmission leak help

    So far ive gotten my transfer case out right behind where that is bolted there is a box bolted on the end of the transmission where the shifter goes. where these two bolt together are leaking bad enough to cause me to loose a couple quarts of fluid every week. I got the shifter out as well and...
  3. Replacing the clutch

    Hi yo all, I need to replace the cluch in a 1989 ford ranger 4x4 5 speed manual .2.9 We I can find here . What are the steps to follow removing The Tc,shafts , and trans. Like a manual, Please help . I need to snow plow soon. Any tips will help.:icon_confused:
  4. tworanger

    M5OD/Driveshaft viabration

    I have had a vibration and harshness problem for the past couple years and have been trying to chase it down. the vibration only shows up in 3,4, & 5th gears when accelerating or decelerating(using the engine as a brake). The noise is the loudest between 25-55 mph. The ranger is an extended...
  5. William Spitzer

    91 dropped 3rd, possible swap

    i got a good deal on a 91 with a 4.0, 4x4, 5 speed, automatic transfer case, with transmission code "M". Its dropped third gear, so im looking to swap in a transmission. I have somebody that will sell me a transmission out of a totaled ranger, which is an 88, 4x2, 5 speed with the 2.9...
  6. 94 Explorer 4WD- Clutch job

    Im having to change the clutch in our 94 Explorer and I just have a couple questions: Does anyone know how to get the y-pipe unbolted? And how do I disconnect the "tranny line"(?) The gold fitting that goes into the tranny near the top on the drivers side. Also, we live in a smaller town...
  7. texastintchick

    HELP! Tranny issue

    So I bought my son a 1999 B2500 standard transmission truck. When I test drove it it was fine. But after I bought it and it had a chance to warm up it would no longer go into gear. It shifts fine for about 20 minutes then if you come to a stop sign and try to shift into any gear... NO WAY...
  8. Boss 302 Ranger Build

    I want to build a boss 302 Ranger but honestly have no idea what transmission to use. I was wondering if anyone could give me some advise on what would be the best way to go. I'd like to use a 2005-2007 Ranger.
  9. Boss 302 Ranger Build Research

    I want to build a boss 302 Ranger but honestly have no idea what ranger to use. I was wondering if anyone could give me some advise on what would be the best way to go. I'd like to use a 2005-2007 Ranger. Basically what I need to know is; can the 5 speed manual transmission that comes standard...
  10. "Jerky" starts/stops.

    All, My truck has been doing this since I bought it and I'm just curious if anyone else has experience with this issue. When taking off from a stop, the truck (transmission I'm assuming) jerks a little bit. It feels almost like something is engaging. The same thing happens when I come to a...
  11. 4x4 to 2WD???

    I have a 4x4 91 Ford Explorer and the transmissions front seal blew and will not hold transmission fluid and so I am wanting to buy another transmission but except I want to change it to a 2WD since my 4x4 will not work anyways, so I was wondering if there was any possible way to be able to take...
  12. M50D-R1HD Creeping/Wont go into gear, NOT the slave cylinder

    Havent posted on this thing in years, but have been having problems with my Tranny. I’ve got an 04 Ranger, Fx4 Level 2, Manual Tranny, 4 wheel drive, 4.0L SOHC. Mazda M50D-R1HD, with Borg Warner 1345 TC At about 40k miles it on the extreme rare occasion would be difficult to get into 1st gear...
  13. Which years are interchangeable?

    I have a five-speed transmission that is from an '86 Ranger. Does anyone know if it will bolt right into a '90 Ford Ranger?
  14. 87' FM145 to 2.3? Will there be issues?

    So I have a question that I hope someone can answer for me. I have an 87' Ranger XLT 4x4 with a 2.9 V-6, and it has over 160,000 miles and has sat for 9+ years. I really don't want to mess with it, and I would like to hop up and swap in a carbureted 2.3L. I want to keep my stock Mitsubishi...
  15. 88 Bronco II tranny problem

    First and foremost I would like to state that I am not sure all problems I am experiencing are related. Almost 2 years ago I had my A4DL rebuilt at a local shop. I picked up my car from the shop and it ran strong shifted well for about a week then started to buck on me and eventually seized. I...
  16. 2006 Ford Ranger Sport 2WD Auto Tranny Slipping

    I have a 2006 Ford Ranger Sport 2WD 3.0L V6 Automatic. It's a daily driver and gets me to and from work everyday. I noticed that while driving on the interstate, when I am over speeds of 65+ MPH and I accelerate (pedal to the metal) it feels like the transmission slips into neutral and over...
  17. 1990 Ranger transmission crossmember/mounts

    Hello, Does anybody know where or even if I can get the mounts as well as a transmission crossmember for my friends 1990 ranger? I'm fairly sure I can pull a crossmember from another 1989-1991 ranger but the mounts are another story. Are there any other ranger models that are compatible with...
  18. 1994 B400 tranny problem

    I am a new member, and have read the forum rules. I am traveling 3,000 miles to daytona, FL in two days, and i need to fix my tranny tonight! i put a complete "clutch kit" in the truck about two weeks ago.. over the past two days, it has suddenly started grinding almost every gear, and popping...
  19. bourcier700

    1997 VSS convert to 2000 VSS?

    Hey I just Put a 2000 auto transmission in my 1997 3.0 ranger and once in place realized that there was no vss on the tail end of the transmission so I went online and read that on 98 and newer rangers they put the vss on the rear end and it works with the abs(i think not completely sure). Is...
  20. Where's the TCM?

    So the speedo stopped working, then the odometer. Then the trans. starts slipping. We changed the sensor on top of the rear diff. Nothing. Took off the instrument panel - no cable - all electronic. Okay, lets change the trasmission. Did that. Still slips and no speedo or odo. Hooked up a...

Sponsored Ad


Sponsored Ad

Top