• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

transmission

  1. 2000 Ranger 3.0 Transmission mystery

    Anyone that can help me with this I would REALLY appreciate it. I have a 2000 Ford Ranger 4x4 3.0 that got stuck in the mud and the tranny started slipping badly. I dropped the transmission tore it down replaced the clutches but over all the transmission looked really clean and I didn't see any...
  2. fully rebuilt automatic transmission wont engage any gears

    I have a 98 Ford ranger 2WD 4 cylinder SOHC 8 spark plug engine I took the AT out my self and had it fully rebuilt I put it back in and bolted it in and then the crank wouldn't rotate to put the TC bolts on flexplate so I loosened the bolts to the transmission and it slid back about a half inch...
  3. Pulling Out Clutch?

    You may have seen my previous posts about getting the fitting that is stuck in the slave cylinder out. Well now I've tried about every reverse drill bit, and easy out that is even remotely small enough to even think about using. (also broke 3 drill bits :lame:). So I'm about give up after...
  4. a4ld failing?

    I bought this 89' 2.9l ranger 4wd, automatic, a few months ago, I'm assuming it never had its tranny fluid changed. its fluid is dark like oil, fluid is full and doesn't leak, it had a little smell but it didnt smell like something burnt i have a feeling the transmission might be going but i am...
  5. '94 Ranger Stuck Gear

    I have a manual '94 Ranger 2.3 liter 2x4 that was given to me by a guy at church. The transmission was low on gear oil, and the gears were beginning to whine. I knew that I needed to top up on the lube, but I didn't. Shame on me. The transmission got really hot one day, and the clutch...
  6. shifting

    ok so i have a 1990 ranger 2.9l v6 4x4 with auto trans, has a rebuilt trans in it, it sat for the winter. my problem is its not shifting right at all, i have to release the throttle to get it to shift but when i try going faster it downshifts again, warm or cold, im thinking it could be a vacuum...
  7. Schwinnstingray1964

    So i need some help.

    About a Year ago, The clutch pedal on my 92 had sunk all the way to floor. I put in a new master cylinder, and the pedal came back up. 1st question, The hose that goes to the slave, Is it supposed to have an o-ring on it? Does anyone have a picture of said o-ring. 2nd question, Where is...
  8. 99 Ranger Tranny not going in to gear when cold

    Hello all. I've got a 99 Ranger 4.0L 4x4. From what I can tell, the transmission code on the build sheet on the door jamb is a 'D' which translates into a 5R55E. There no service lights being illuminated on the dash. Please correct me if I am wrong. However, I am not sure how I have a 5...
  9. 92 ranger stx clutch issues?

    ok, so my kid brother has a 92 ford ranger stx 4x4 with a 2.9L engine and a 5 speed standard trans. i have not had a chance to look at it yet but he says that in the morning when it's cold the truck is hard to get into gear as if the clutch is not disengaging and later in the day as it warms up...

Sponsored Ad


Sponsored Ad

Top