File Sharing! Anyone have any handy Ranger Related STL and DXF files to share?

[PlumCrazy]

I wanted to start a thread for sharing useful files for 3D printing and/or CNCing stuff for Rangers

With how affordable 3D printers are and how easy it is to have things made by CNC like through Send-cut-send etc.... I why not share files here for Ranger related stuff

I'll start by attaching this M5OD support block STL I whipped up for sitting the trans on a trans jack without it constantly trying to slide off or roll over.

I'm somewhat new to the 2D/3D data world so if there are other file types that would be helpful lets discuss them here. I know @Jim Oaks has enabled STL and DXF so far.

 

[Shran]

Here's a handful of tabs & brackets - these are all my drawings

 

[Shran]

RBV Related: TTB coil spacers. You can get these at Bronco Graveyard but since I have a plasma table I drew my own version and cut them as needed. I use 1/4" plate, you need 1-2 of the hex ones to start with and then as many round ones as you feel are necessary on top of those. Great for levelling your truck side to side.

 

[97RangerXLT]

this thread is pure excellence... keep this stuff coming.

AJ

 

[PlumCrazy]

this thread is pure excellence... keep this stuff coming.

AJ

I try to contribute to society every now and again.

 

[RobWigglezz]

I'll draw this up at work tomorrow. I kinda just winged it when I made it.

 

[Jim Oaks]

I don't know much about this. When Plum contacted me about it I told him I'd make it so that those file types could be uploaded. If anyone has a problem uploading, please let me know. The plan is to organize these on a page on the website as a resource where they'll be organized and easy to find.

 

[Shran]

It would be helpful if people sharing files could do a screenshot of the part or a picture of the final results. I am planning on going back and doing that for my tabs & brackets post, my CAD program is acting up so I'll go back & edit it once I have it fixed.

 

[Roert42]

I'll draw this up at work tomorrow. I kinda just winged it when I made it.

Those plastic bodies always tend to be broken. I made one from a chunk of 10ga stainless a few years ago.

 

[PlumCrazy]

It would be helpful if people sharing files could do a screenshot of the part or a picture of the final results. I am planning on going back and doing that for my tabs & brackets post, my CAD program is acting up so I'll go back & edit it once I have it fixed.

Same thing I was going to do.

 

[Shran]

Also related: if any of you have plasma/laser/water jet tables or access to one, Langmuir Systems has a free file sharing page on their site. I have found a few things in here that were really handy so that I didn't have to draw things from scratch. Mainly signs, letters, and stuff like that but there are also a large number of tabs and builder parts.

Explore | FireShare | Langmuir Systems

www.langmuirsystems.com