shadetreebronco
Member
- Joined
- Feb 15, 2015
- Messages
- 156
- Reaction score
- 0
- Points
- 16
- Location
- Connecticut unfortunately.
- Vehicle Year
- 75 87 96
- Make / Model
- Ford
- Engine Size
- 351W , 2.9L , 4.0L
- Transmission
- Automatic
My 87 Bronco II exhaust has been hacked up pretty bad and is on my repair list.
The 3 bolt oval Y pipe flange and Cat flange have been cut off , 2 smaller diameter pipes installed between two and welded up like a rock from a Roswell New Mexico crash site.
I am finding the factory 1990 Y pipe and Cat would bolt right in but cost about $400 with factory type cat.
If the 2.8 y pipe with the round 2 hole flange fits the 2.9 manifolds the Cat options and cost change quite a bit.
The 3 bolt oval Y pipe flange and Cat flange have been cut off , 2 smaller diameter pipes installed between two and welded up like a rock from a Roswell New Mexico crash site.
I am finding the factory 1990 Y pipe and Cat would bolt right in but cost about $400 with factory type cat.
If the 2.8 y pipe with the round 2 hole flange fits the 2.9 manifolds the Cat options and cost change quite a bit.