Latest activity
-
BL00DPIG replied to the thread Sounds like popcorn popping in my exhaust Bank 1.Well, It was a "dead" Chevy but an old S10 with a 14' Jon boat. Usually my Ranger would pull this no problem. However, this time she... -
BL00DPIG replied to the thread Sounds like popcorn popping in my exhaust Bank 1.OK. I was going to go buy a vacuum gauge this morning. While waiting for the store to open, I decided to test the MAF sensor per these...
-
Bracket racer replied to the thread WHAT DID YOU DO TO YOUR RANGER TODAY?.Replaced a couple front wheel bearings, replaced the front pads, cleaned up the calipers, unhooked the seized park brake cable, pulled...
-
STPL replied to the thread 94 2.3l rough idle when warm, worse after new radiator. Possibly mass air flow sensor?.Quick update: I tested the vacuum on the line from the old EGR solenoid to the EGR valve and the vacuum pull wasn't very consistent when... -
Uncle Gump replied to the thread Junk Yard Hunt For 16's or 15's.In my humble opinion... the best solution is to just have a pair of wheels that fit. Adding a spacer so your other spacer fits... is a... -
Uncle Gump replied to the thread WHAT DID YOU DO TO YOUR RANGER TODAY?.Or a barn cat...
-
Uncle Gump replied to the thread Changed passenge-rside timing chain tensioner....The lower oil pan (at least on a 4x4) isn't bad to drop. If the guide is coming unglued... the evidence will be sitting in the lower oil...
-
Uncle Gump replied to the thread B2300 running weird! HELP!.Improper fuel delivery... if you aren't getting the right fuel pressure... it won't meet the engine demands. It almost seems you might...
-
Uncle Gump replied to the thread Wheel bearing help.Just pick yourself up a nice long drift punch... probably 12 inches long... use that to drive the races out. Most parts stores might...
-
ericbphoto replied to the thread New Here. So I thought I'd drop in.Welcome! The truck looks good. -
adsm08 replied to the thread Wheel bearing help.Well Sandman walks through life with his eyes half closed. It's not his fault, comes with the name. Unless you are getting Motorcraft... -
Uncle Gump replied to the thread Kirbys 1991 Ranger Build Up and Solid Axle Swap.That truck would look good even if you painted it with multiple colors of your wife's left over finger nail polish... I like the...
-
ericbphoto replied to the thread Wheel bearing help.It’s better to use the races that come with the new bearings. They are machines as a set and should match up better and last longer. The...
-
ericbphoto replied to the thread WHAT DID YOU DO TO YOUR RANGER TODAY?.A mouse trap might be in order.