Sploder 8.8+ 1991 2wd swb ranger +Bronco II rear sway bar= success?

[marauderx]

Will that equation work? I don't want to go wasting more time if some one else has had good/bad experiences to share. Thank you in advance!

 

[marauderx]

I got one, and I am going to give it a shot...

 

[An Audio Guru]

Got a lot of sway I'm my butt. Extended cab 92. What did you learn on this? I'm gonna tackle my wandering behind soon. Hope you found out some useful info!!!

 

[Xeek]

ranger axle tubes are 2.75" or 2.8" OD. exploder are 3.25" OD. the brackets wont fit. i would imagine find some 3.25" sway bar brackets or carefully cut off the exploders brackets and weld them on to use the stock/broncoii bar.
but the bronco ii bar is 1" right? 95-01 exploder bars are 1" also. i would just use that since its already setup for it on the axle.