So...its been a while since I last posted. Been working on it when I can, and actually have been reassembling the engine this week.
Question: Misread the torque wrench and definitely went over at least 5 maybe 10 ft. lbs. on the cylinder head bolts, went over on all sequences, but figure the final one is pretty important. So manual says 63-73, I did at least 78 ft. lbs. Do I need to stop right now before I get too far ahead and redo all of this? Or can I just roll with it?
Didn't notice until I was torqueing the exhaust manifold bolts...