- Joined
- Jun 13, 2016
- Messages
- 134
- Reaction score
- 40
- Location
- Connecticut
- Vehicle Year
- 1989
- Make / Model
- Bronco ii
- Engine Type
- 2.9 V6
- Engine Size
- 2.9L
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- 6
Alright ladies and gentlemen, back again with another problem I could use your help with. I’m having difficulty finding the correct order to connect my fuel injector wiring harness to the injectors. “I HAVE seen the thread about it but I’m skeptical still”, last time I went messing around with my injector wiring I backfired the engine and caused a fire. Adding to everyone’s opinion that I should just dispose of the truck before it makes me go bankrupt at the ripe age of 22...sooo I want to make sure I get this perfect the first time. I know the 2.9 is a bank fire system and from my understanding the green and white wires go to one bank and the red and tan to the other? Correct? That being said what are the banks cylinders 1,2,3 and 4,5,6? I’ve found a few sources in the ford truck forums saying as much and on here I saw cylinder 2,4,1 and 6,5,3. What would be really helpful is a picture of someone’s harness on the truck so I could see which wire is going to which injector. Side note the truck body is an 89 the engine is an 87(if that matters at all) also from my understanding the wires going to each bank don’t matter particularly which injector they go to as long as it is in the correct bank right? I just went through and rebuilt the engine, ran it, caught it on fire, and then replaced the whole electrical and ignition system AGAIN, all of this was my own fault but before I turn that darn key again I want to be sure I have my fuel system wiring 100% correct
-Jon
-Jon