85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 33,021
- Reaction score
- 19,729
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
I picked up new pivot bushings for my D35, reading in my faithful Haynes manual it says after being pressed in they must have the one side that doesn't have a flare flared to hold them in place. Use a special tool available at most parts stores blah blah blah.
Not surprisingly nobody has heard of said special tool. Is there another way to do it? Any ideas?
I hate to go buy the special tool when I am likely ever going to need it to do two bushings...
Not surprisingly nobody has heard of said special tool. Is there another way to do it? Any ideas?
I hate to go buy the special tool when I am likely ever going to need it to do two bushings...