302/aod/carb/& lokar parts

[jmcleek]

has anyone Used these fine lokar parts with a aod?

instrutions http://www.sitelevel.com/click?url=http://www.lokar.com/downloads/pdf-instructions/ford_aod_kd_kit.pdf&sid=2ccm8Y62SXVKJrA5

brackets http://www.summitracing.com/parts/lok-srk-4000/overview/

throttle http://www.summitracing.com/parts/lok-tc-1000ht
kickdown kit http://www.summitracing.com/parts/lok-kd2aodht/media/images

Thanks John

 

[v-8power]

I have both the throttle and tv cable from lokar. I am only using the throttle cable right now and really like it, i got the tv cable when i bought the transmission, and just have not put it on.

It is a lot better quality then the generic one AutoZone sells. IMO

 

[Scott B.]

I am using a Lokar throttle cable and TV cable as well.

Very high quality products.

 

[85_Ranger4x4]

Their dipsticks are crap though, they plug a hole and that is about it.

 

[jmcleek]

Went ahead and got the kickdown, maybe in a few weeks get the rest.

Any problems with the install ?

 

[doorgunner]

I added a transmission pressure gauge to my instrument cluster (really not necessary but I like to know what it's doing since it's got 213,000 miles on it)
Pressures are good thru-out the shifts...but it's a little slow engaging drive

 

[Scott B.]

Their dipsticks are crap though, they plug a hole and that is about it.

I have one of their dipsticks, too. It looks good, but is a PITA to read the level and fill the trans.

 

[doorgunner]

I have one of their dipsticks, too. It looks good, but is a PITA to read the level and fill the trans.

I always clean the dipstick end with gas/sandpaper it a little/spray paint it with hightemp black paint/let it dry overnite.....

makes reading the fluid level a lot easier.....

 

[jmcleek]

I see it says in the instructions in step # 8 to use a oil pressure gage attached to the T.V. port on the transmission. can anyone tell me where this port is? A pic would be grate.


Instrutions http://www.sitelevel.com/click?url=h...cm8Y62SXVKJrA5

thanks John

 

[85_Ranger4x4]

I always clean the dipstick end with gas/sandpaper it a little/spray paint it with hightemp black paint/let it dry overnite.....

makes reading the fluid level a lot easier.....

The only way I could was to drag my finger nail along it until fluid started pilling up in front of it.

PITA to fill a trans through a 1/4" straw as well.

 

[jmcleek]

I found this writeup on ford muscle forums http://www.fordmuscleforums.com/transmission-articles/470612-c4-aod.html