My Bronco 2

[kroussinoffroad]

you dont know how jealous i am...






you have green grass allready, and you have one sweet B2

 

[4.0B2]

Man we've already had to cut our grass once! Hahahaha

 

[disciplerocks]

I just moved a month ago and have too many projects going on at the same time so I'm glad I haven't had to deal with that yet.

 

[kroussinoffroad]

ugh. i kinda hate you right now. but it's kinda nice the top 2 inche's of exposed ground (very little) thaw's during the day and turn's into extremely snotty mud. then freeze's back up over night. so i think when the BIG spring thaw come's there is gonna be gob's of mud to playin.

 

[4.0B2]

Mud takes to much clean up.. I'll play in some but not a lot.

I'm picking up a HP d30 Saturday!!

 

[railman]

I have to agree.....you have one sharp BII

l8r, John

 

[4.0B2]

Thanks y'all.

 

[kroussinoffroad]

you can have my 30 as well if you want it. need's 1 new unit bearing. altho i think i danger83 has dib's on my 297 shaft's.

 

[4.0B2]

to bad shipping would suck... what gears and stuff are in it?? i'm gonna need gears and brake stuff.

i'm getting a HP 30, TJ shafts (297's), and some XJ shafts (idk what joint tho)

 

[kroussinoffroad]

arent the TJ's all LP? and xj's ran three different shaft's. small joint/disconnect, small joint, and big joint. mine is just the run of the mill's hp30 3.55 gear's big joint. nothin spectacular. however a aussie locker just popped up on CL not to far from here.

 

[4.0B2]

how much is the aussie?? lol, i can't afford it right now.
tj's were LP but was told that the shafts would still work
http://www.rme4x4.com/showthread.php?p=203412
plus i believe the xj shafts are the larger joint.

i think i'm gonna buy all new brake stuff, probably from rockauto.com
but even after i build the d30 i still have to afford those freaking long arms... dang expensive things. may try to make some!!!

and does the offer on the 30 include shipping fees to walls, ms?? lol

 

[lethal-threat-b288]

do you have the design for your bumper? and how do you have your fenders cut in the front?

 

[4.0B2]

design, no... lol. it was just made. the guy that made it is a master fabricator. lol. he's old skool, used oxy/ace torch and arc welder! lol.

as far as the fenders cut-- they are a straight cut on the body line (it actually angles up slightly towards the rear).

see the tape? i cut at the bottom of that tape with just a cut off wheel, cut the inner just a little higher. BUT I LEFT THE TABS THAT THE FRONT PIECE BOLTS ON WITH. and then drilled a 1/4 inch hole in the lip of the wheel well in the metal and inner fender and put a 1/4 inch rivet it in.

this picture is kinda showing how i cut it, but i followed the body line a little above the orange line in that pic

 

[kroussinoffroad]

yeah if the shipping were free then yeah.. otherwise i dont think it would be worth shipping a used D-30

 

[4.0B2]

yeah if the shipping were free then yeah.. otherwise i dont think it would be worth shipping a used D-30

not when i'm about to go pick one up in the next couple hours.