I want to change 1994 bench seat!

[keithuram]

I know that many posts refer to changing seats, and I've looked at the Tech Page on this subject. But I've found nothing about this, specifically. I have a 1994 regular cab 2wd with a straight bench seat. Is it possible to swap this to a 40/60 bench or even to buckets? I don't see how it would be possible. Does anyone know if I can, and if so, what seats will go in without too much modification? I found a 1999 40/60 bench and wonder if that will fit. Thank you to anyone who can help.
Keith

 

[nitrofan1]

If I recall the floorboards are stamped the same. the holes for the bucket / 60-40's should either be pre-drilled or the dimples are there to tap them out. You will probably have to pull the carpet / mat to see them. Once that is done you should see them.

 

[graff104]

If I recall the floorboards are stamped the same. the holes for the bucket / 60-40's should either be pre-drilled or the dimples are there to tap them out. You will probably have to pull the carpet / mat to see them. Once that is done you should see them.

Yep it should be no problem. I went from bench to 60/40's and now back to the bench in my 1994 regular cab 2wd with the straight back bench.

 

[colordranger27]

i dont like my 60/40..i want to try a bench next

 

[Scrambler82]

i dont like my 60/40..i want to try a bench next

It is just like a bench with a fold down console and the Co-Pilot can move their seat independently.

 

[redbird]

remember to get the tracks as well as the seats, and remember that the reg cab tracks are different than super cab tracks so stay with what you have

 

[baxtej44]

i don't like 60/40, and got some buckets... need some fab work done though.