- Joined
- Jan 16, 2026
- Messages
- 12
- Points
- 101
- City
- Oaktown
- State - Country
- CA - USA
- Vehicle Year
- 2008
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Automatic
For 2008 Extended Cab...
Due to severe misadventure culminating in some theft and rogue dismantling...
We're in bad need of following parts...
I'm in Oakland Calif. Close by would be wonderful but if not we can get the parts transported if not cost-prohibitive.
Thanks in advance for your help.
KD
Due to severe misadventure culminating in some theft and rogue dismantling...
We're in bad need of following parts...
- 60/40 seats, preferably in really good shape (ours were in great shape, after trying to find good replacements I understand why ours were stolen).
Ours is an extended cab but I think it's true that seats from a standard cab will work if I put 'em on the tracks from an extended cab? I think any year from 2004-2011 is the same.
- Fuel tank, ours got torn up and has an excellent bunch of holes in it
AFAIK any year from 2004-2011 will work fine so long as it's from an extended cab 126" wheelbase because standard cab tank isn't the same
- Tail Lights, passenger side one was stolen, the driver's side one smacked up bad
Again AFAIK any year from 2004-2011 will work fine, and AFAIK lights from standard cab are the same as from extended cab
- Skid Plate: Had a nice one, now it's a goner
Here too AFAIK any year from 2004-2011 will work fine but I'm pretty sure it it must be from standard cab, and I think maybe after 2008 they changed the mounting setup/brackets for the ext cab skid plate? At least I think I've seen 2 different stock setups for extended cab skid plates. So whatever Gen V skid plate you might have, it'd be great if I could also get whatever mounting hardware goes with it.
I'm in Oakland Calif. Close by would be wonderful but if not we can get the parts transported if not cost-prohibitive.
Thanks in advance for your help.
KD

