disciplerocks's B2 build thread

[kris97ranger]

you try any double low 2wd burnouts yet?

 

[disciplerocks]

Not going to happen.

 

[Robert_1967]

I don't mean to take this off topic, but seeing that you just did a heck of a job building the transfer case, and all, I figured you might know the answer to this.

My sister has a 74 F250 4x4 with a 300 inline 6 and 4 speed bulldog trans, it has a single stick transfer case.

the problem is that the truck at 50 mph is really winding the engine.
the question is "can a single stick transfer case be stick on the low side and still shift to 2wd? "

and I have no idea what trans case is in it

Robert

 

[kris97ranger]

You got it to go 50 mph?! My dad had that truck u were lucky to get it to do 80km/h.... they arnt meant for daily driving or going fast. its meant to pull shit theyre good at that. Id say ur probally getting as good as u can

 

[disciplerocks]

The answer is no, and while I'm not familiar with the tranny/tcase in question, the fact that its a 4 speed means you don't have overdrive and you'll be hitting high rpms on the highway.

 

[Robert_1967]

OK, thanks, I was just wondering.


OK, back to the build.



Robert

 

[disciplerocks]

Speedo cable from the F250 I got the front shaft from. Maybe now my speedo will work.

 

[disciplerocks]

How in the hell?

 

[86 slo-vo]

Rick did the same thing.

 

[CHKNFKR]

How in the hell?

that's not so bad. I've seen them scrunched up like an accordion....

 

[Robert_1967]

What is that and where does it come from ????

I can see that it has been split.


Robert

 

[Bennybooster]

Its a spindle nut

 

[escort_gts]

Its a spindle nut

WAS a spindle nut

Sent from my HTC using Tapatalk

 

[disciplerocks]

Phew been busy. All thats left is to wire this up and make an attempt to re-weld the rear.

 

[kris97ranger]

How in the hell?

Did the same.thing in my sammi... didnt work out well