cab corner

[tiredmec]

Going to make my own cab corners. Just cant seem to remember trick to curving at a angle. If I cant figure it out again may have to cut a few areas to match radius. Don't have shrinker or stretcher. Have home made bender but been using thick steel and clamps and hammers. Just have rear cab corners and pass door bottom have metal bent for door. the front fender bottoms just going to fiberglass there not that bad. Have dollies and hammers. and a flange maker. But I prefer to but weld. I do have the clips to hold panel together. any Ideas on corners.

 

[scotts90ranger]

I haven't tried but if you can bend the right radius I would probably pie cut the back side on the side that needs to bend in then massage and weld as needed... only other trick I know of is heating then cooling with a wet towel but I never remember if that makes things bigger or smaller...