- Joined
- Jan 12, 2021
- Messages
- 779
- Reaction score
- 827
- Points
- 93
- Location
- Walkerton Va 23177
- Vehicle Year
- 1988
- Make / Model
- Ford Bronco II
- Engine Type
- 2.9 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 3"
- Tire Size
- 31x10.50R15
So on my 88 BII (Auto, electric 4x4, power locks/windows) the main engine harness and connectors at the left inner fender are trashed. I have scowered the internet and junk yards and came across a 2 wheel drive automatic 88 2.9 ranger( manual windows and locks) and got the engine harness, looks perfect. Also got the dash harness to get the connectors on the left fender well. As I replaced it last night I ran into a few connections that were not the same. Any assistance would be greatly appreciated or if it will not work at all I need to know. Same part # letters at the end are different. I'll have to crawl back in the dash and find the ones on the "new" harness.
Main connector concern is under the dash near the tunnel it is a square with one side domed. The dome and orientation notch are exactly opposite on the two harnesses..?
The other 2 concerned are inside the outer most portion of the dash on the left, new harness has 1 connector with less terminals, the other isn't there. Could not get a good pic.
Main connector concern is under the dash near the tunnel it is a square with one side domed. The dome and orientation notch are exactly opposite on the two harnesses..?
The other 2 concerned are inside the outer most portion of the dash on the left, new harness has 1 connector with less terminals, the other isn't there. Could not get a good pic.