Punisher
New Member
- Joined
- Dec 21, 2007
- Messages
- 68
- Reaction score
- 0
- Points
- 0
- Location
- Missouri
- Vehicle Year
- 1988 Bronco II,
- Transmission
- Automatic
Got her all painted up ready for the date with destiny
Building a Rockwell......finally
got it under the front coils, now the install of the components.
First the new boots:
Unzip the old ones and undo the clamps, then zip the new ones on and reinstall the clamps, it is harder then it looks, but at the same time not to bad.
Next installing the axles, it is pretty much like any straight axle dana axle from here out.
Bolt on the spindles
As you can see it has the standard looking spindle with the two big bub bearings.
Next the hub goes on, I won't do the drive flanges yet but they go on where the lockout normally would.
Building a Rockwell......finally
got it under the front coils, now the install of the components.
First the new boots:
Unzip the old ones and undo the clamps, then zip the new ones on and reinstall the clamps, it is harder then it looks, but at the same time not to bad.
Next installing the axles, it is pretty much like any straight axle dana axle from here out.
Bolt on the spindles
As you can see it has the standard looking spindle with the two big bub bearings.
Next the hub goes on, I won't do the drive flanges yet but they go on where the lockout normally would.