• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Received 0 Likes on 0 Posts 4r44e OD off won't move forward or reverse


gezitz57

New Member
Joined
Sep 19, 2021
Messages
10
Reaction score
0
Points
1
Location
Georgia
Vehicle Year
1999
Make / Model
Mazda B2500
Transmission
Automatic
I had installed a new TSS sensor when I rebuilt it.. I checked the resistance at the transmission harness connection point and the resistance of the TSS is right in the middle of the resistance range. So I don't think the TSS is the issue. I previously had wiring issues right behind the motor where the insulation had rubbed off. I took a lot of time to recover each wire and then put it a sheath to protect it. So I don't think so but that is where I am going to start looking.
 


gezitz57

New Member
Joined
Sep 19, 2021
Messages
10
Reaction score
0
Points
1
Location
Georgia
Vehicle Year
1999
Make / Model
Mazda B2500
Transmission
Automatic
The speed sensor on the rear end was replaced when I rebuilt the trans. No wires are pinched. I am trying to find the time to check each wire and pin out to see if I can isolate the issue.
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top