- Joined
- Apr 28, 2008
- Messages
- 387
- Reaction score
- 7
- Points
- 18
- Location
- Fresno CA
- Engine Size
- 4.0
- Transmission
- Manual
Having a CB for years I have never had a good place to mount the mic. I always laid it on the seat or center consul. Now that I have my HAM license and plan on adding a second radio to the truck I needed to add a way to store the mics. Looking around the truck I decided just below the radio would be the best spot.
Some measuring and a bit of time on the computer I drew up a bracket and cut it on my plasma table. A few bends and welds and this s what I had.
20150907_155936 by Matthew Dresselhaus, on Flickr
Here it is temporarily mounted with some tape to double check everything.
20150907_160823 by Matthew Dresselhaus, on Flickr
I drilled a few holes and used pop rivets to hold it in place. Until I get a vehicle mounted ham it will hold my hand held as well.
20150908_142655 by Matthew Dresselhaus, on Flickr
Some measuring and a bit of time on the computer I drew up a bracket and cut it on my plasma table. A few bends and welds and this s what I had.
20150907_155936 by Matthew Dresselhaus, on Flickr
Here it is temporarily mounted with some tape to double check everything.
20150907_160823 by Matthew Dresselhaus, on Flickr
I drilled a few holes and used pop rivets to hold it in place. Until I get a vehicle mounted ham it will hold my hand held as well.
20150908_142655 by Matthew Dresselhaus, on Flickr