RoboCop
New Member
- Joined
- Feb 5, 2019
- Messages
- 1
- Reaction score
- 0
- Points
- 1
- Age
- 48
- Location
- Tver, Russia
- Vehicle Year
-
1988
1989
- Make / Model
- Ford
- Engine Size
- 2.9 (177)
- Transmission
- Manual
- My credo
- Dum vivimus, vivamus
Hi, comrades! It's my first question on this forum. Before I was just only reader for some years.
So, I have a trouble. During work on my new Bronco II I found that right exhaust manifold was cracked by two pieces. Car - is regular 1989 Bronco 2, XLT, 2.9 EFI, 4x4. I live in Russia and it add troubles with it.
I can buy a new exhaust manifold from Rockauto, but shipment from USA will be costs for me more than manifold itself. It hurts. So - it will be a "Plan B" if all other thing will go wrong.
I trying to find it from "junkyards" here, but our aftermarket for such parts is bad. Such cars like Bronco 2 in Russia is becoming less and less, respectively, too few parts. I can't find used manifold from 2.9, but there is from Explorer's 4.0 (first generation).
And finally question is: will the exhaust manifolds (right and left) from Explorer's Cologne 4.0 fit to the 2.9 Bronco II's heads and Y-pipe?
I don't want to change Y-pipe to Explorer's so I have that question.
I know that partnumbers for Bronco2's and Explorer's manifolds differs. But visually they differs not too much. So - is there some hope for me?
Or I must use only original for 2.9?
Has anyone encountered a similar problem?
So, I have a trouble. During work on my new Bronco II I found that right exhaust manifold was cracked by two pieces. Car - is regular 1989 Bronco 2, XLT, 2.9 EFI, 4x4. I live in Russia and it add troubles with it.
I can buy a new exhaust manifold from Rockauto, but shipment from USA will be costs for me more than manifold itself. It hurts. So - it will be a "Plan B" if all other thing will go wrong.
I trying to find it from "junkyards" here, but our aftermarket for such parts is bad. Such cars like Bronco 2 in Russia is becoming less and less, respectively, too few parts. I can't find used manifold from 2.9, but there is from Explorer's 4.0 (first generation).
And finally question is: will the exhaust manifolds (right and left) from Explorer's Cologne 4.0 fit to the 2.9 Bronco II's heads and Y-pipe?
I don't want to change Y-pipe to Explorer's so I have that question.
I know that partnumbers for Bronco2's and Explorer's manifolds differs. But visually they differs not too much. So - is there some hope for me?
Or I must use only original for 2.9?
Has anyone encountered a similar problem?