- Joined
- Jan 5, 2009
- Messages
- 4,510
- Reaction score
- 36
- Points
- 0
- Location
- owensboro, KY
- Vehicle Year
- 1994
- Make / Model
- ford
- Engine Size
- 4.0
- Transmission
- Manual
Jd2 model 3 tube bender
Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
ok thats good i might cut it back then notch it on the bottom some how to make it sit up higher. 97trailrigs bed is nice too that seems like a good bender for the price.no, it won't make the frame any weaker by cutting a few inches off and capping it....
also check in this forum for 97TrailrigDD's tube-bed build....also a done with a JD2 bender....
l8r, John
umm not sure how much are u looking to spend? i dont know of any but there is a winch bumper for sale near me with a 10,000k winch on it for 475 for a gen one ranger or b2.For those of us with limited fab exp. Where can you get a bolt on winch bumper strong enough to pull a bulldozer with?