86RangerXL
Member
- Joined
- Feb 28, 2022
- Messages
- 45
- Reaction score
- 11
- Points
- 8
- Location
- Tallmadge, OH
- Vehicle Year
- 1986
- Make / Model
- Ford Ranger
- Transmission
- Automatic
Sorry for posting a new question almost every day, my pile of junk has a lot of problems. Anyway, I put on a new intake manifold gasket, put the actual manifold on, and then when I go to put the distributor in, it refuses to go in. I marked out exactly where it was when I pulled it out, and trying everything from pushing on it, turning the rotor, and even rotating the engine very slightly got nowhere after trying for an hour. It stops a little under 1/2 inch from the O ring. I looked down the hole and it seems like the spline it goes on isn't centered. Is this normal?
Attachments
-
138.1 KB Views: 59