kiragyu
New Member
- Joined
- Dec 4, 2009
- Messages
- 224
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1998
- Make / Model
- mazda
- Engine Size
- 3.0V6
- Transmission
- Automatic
so i swapped in a 06 ranger 4.0 into a 98 mazda b3000 well the speedo doesnt work because its connected to the output shaft speed sensor on the tranny. well i know i should swap in a new gem module to make everything work right but i was wondering if i could just splice my old speed sensor into the output shaft speed sensor wires and have the speedo work till i get everything figured out. please help asap