• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

mazda


  1. 1999 Mazda B2500 SE--worth it?

    Hi Ranger Experts, I'm considering purchasing a '99 Mazda B2500 SE 2D for $3,500. Manual transmission, 87,000 miles, no rust, in great aesthetic condition. What worries me is that according to the TRS buyers' guide, 1999 is a really bad year for recalls/general problems for the Ranger. And...
  2. Thing My 4.0 is about dead

    Hello everyone I have a 94 B4000 that I bout about a year ago to take to the mountain and beat the crap out of. witch I did indeed to haha. anyway my first question is it to run the v6 with open headers because due to doing a new clutch system ( slave and master) I cut the y pipe out right after...
  3. What do you guys think of this?

    I'm totally new here and made an account kinda for the purpose of this post. I'm currently looking at buying a pickup and found what is seemingly a good deal on a 94 Mazda B4000. I'll post the link to the listing at the bottom of this post. I was wondering if this is a good buy. I'm pretty...
  4. 95 B2300 2.3L low fuel pressure at KOEO

    Symptoms: Tough to start, if it does not fire on the first key turn, I have to hold the pedal to the floor until it starts. A little hesitation when driving Symptoms started after replacing the fuel filter and spark plugs and plug wires. I have a problem of having 5 psi of fuel pressure when...
  5. B2300 cannot pass emissions!!

    A
  6. 96 b2300 emissions help! Aborts test

    Hey guys I have a 96 b2300 2wd that needs to pass emissions by January. The test center said they cannot get a reading from the truck. I have never reset codes/unplugged battery. The mechanic suggested a new thermostat is very common for this type of truck and issue. I have been looking at...
  7. Code 29 air bag sensor light?

    I have a 2001 Mazda B3000 Extended Cab 2WD. Everytime I start the vehicle the air bag blinks in a 29-blink code. I don't know what the problem is, tryed connecting and cleaning my sensors and wires under my seat. Just not sure what to do. Any feedback would be great, thank you' -Chris
  8. Same Header Panel?

    I have a 2001 Mazda B3000 2WD Extended Cab, with no real modofications yet, but I want to put on a custom prerunner bumper from a company. The company says I must have a ford ranger header panel in order to install their bumper. Does this seem right? If so please help explain to me how to...
  9. 1994 b4000 idle/rev issue

    1994 Mazda b4000 4x4 216,xxx No mechanical issues other than a leaky break hose and one I can't figure out, on occasion when stopped or on neutral the rpms jumps and the engine revs, like if the brake weren't depressed or it was out of gear it would lurch forward, like...vuh! Buhbuhbuhbuh vuh...
  10. B3000 DS 4x4 conversion

    Hey guys, I'm doing some research on converting a 2002 Mazda B3000 Dual Sport from 4x2 to 4x4. I know everybody says that this is too hard to justify, and that it's better to just sell and save up for a 4x4, but hear me out :) First of all, I've heard that changing a rear-wheel drive to 4wd...
  11. Best Parts for tune-up?

    Hello all, I just purchased a 1996 b2300 4cyl. Automatic. The truck has 103,000 miles on it. I got the timing belt changed but could definitely use some new parts and tune up. Asking for advice on what parts to replace which will give me most bang for my buck. Spark plugs coils radiator...
  12. Mazda B4000 Vibration

    Help needed please, I replaced U-Joints, Carrier Bearing, marked the driveshaft so I put it back together correctly and now I have a terrible vibration. At low speeds (15-35 mph) it feels like the rear end is hopping. At 45+ mph the entire truck goes into what feels like space shuttle re-entry...
  13. TwooD

    Need Advice!

    Hey guys, I'm new to these forums and I recently picked up a 99 Mazda B4000 4x4, and I am just wondering what are some cheap things I can do to improve the overall look of my truck. I have big plans but no money at the moment. I have already put the spray in bed liner in the box and blacked...
  14. TwooD

    Help with a lift kit!

    Hey guys, im sort of new to this and i just got my first truck a couple weeks ago, a 1999 B4000 4x4 and im just curious as to what lift kits would you guys suggest for it? I am unsure as to what id need, I want 3 or more inches. thanks! :)
  15. Edgefevah

    Mazda B4000

    I am wondering if a hood off a 1994 Mazda B-series pickup will fit my truck? Found one that has a sort of "powerdome" look to it, looks like a fit just not entirely sure.
  16. '91 B3000 a.k.a The Green Goomba

    Ok, I've had this truck for a little over a year and a half and LOVE it. Here are a few pics of what I've done to it so far (mostly interior work) The truck the day I bought it Painted the Bumpers BLAAACK! Now I am a car audio enthusiast so, the next steps are understandable... Took...
  17. could use buyer advice

    so ive finally given up on my 1994 long bed 4cyl auto the trans has gone one too many times. my dad has found me a 1996 mazda b4000 4x4 5spd its a nice truck black looks pretty good but im weary about the mazda because im not sure how close it is to a ranger. ive been told that the ranger has...
  18. Nezorf

    My 1996 Mazda B2300 2.3L Manual Clutch Adventure!

    My 1996 Mazda B2300 2.3L Manual Repair Thread. Current Issue: Temp Gauge I thought I would start a thread for questions about my truck but also as a subsequent diary/walkthrough. My background: Ex-Motorcycle mechanic Basic car maintenance know how (oil changes, brakes, etc) General tinkerer...
  19. bblatch69

    gibson, magnaflow, or ?

    I was looking into cat back set ups for my b4000 with the 4.0 sohc, just wondering if anyone could give me some input on what brand would be the best? i want something that sounds good and deep outside, but quiet in the cab. thanks! :icon_thumby:
  20. brandothehick

    Front lift help

    96 mazda b4000 Front lift help i have a 96 mazda b4000 4x4 and my front is 4in lower then my back. what is the best (cheap) way to lift the front to even it out, and so i can put 33' or so tires on it. Would it be ok for me to just put front coil springs on that are 3in higher, or just 2in...


Top