TheStig88
New Member
- Joined
- Nov 15, 2008
- Messages
- 65
- Reaction score
- 0
- Points
- 0
- Location
- Columbia, Missouri
- Vehicle Year
- 96,06,84
- Make / Model
- Ford
- Engine Size
- 2.3L
- Transmission
- Manual
Apparently my flywheel has a deadspot....
The starter will not engage when near this spot, it just spins until I rotate the crank by hand
I've tried adjusting the starter but it didn't improve
So.....I'm looking at pulling the motor to change the flywheel ( and while its out I'll do a complete gasket and seal job)
Or maybe I'll just drop in another motor.....maybe a built up n/a 2.3?
Opinions, ideas and options would be appreciated
The starter will not engage when near this spot, it just spins until I rotate the crank by hand
I've tried adjusting the starter but it didn't improve
So.....I'm looking at pulling the motor to change the flywheel ( and while its out I'll do a complete gasket and seal job)
Or maybe I'll just drop in another motor.....maybe a built up n/a 2.3?
Opinions, ideas and options would be appreciated