rocks
Member
- Joined
- Feb 10, 2009
- Messages
- 92
- Reaction score
- 0
- Points
- 6
- Location
- new mexico
- Vehicle Year
- 1994
- Make / Model
- Mazda
- Engine Size
- 4.0
- Transmission
- Manual
I have a 1990 bronco ii with a factory Dana 35. It came from a junkyard, passenger side beam had been cut with a torch at one point. I swapped in a Explorer beam and knuckle on the passenger side. Didn't touch the driver side. Now the passenger side tire sticks out almost 2". It aligned fine, drives fine, four wheel drive works.
I didn't notice at first due to the core support being smashed, changed the front clip to a 1986. Is there a difference in the Bronco ii dana 35 width?
I didn't notice at first due to the core support being smashed, changed the front clip to a 1986. Is there a difference in the Bronco ii dana 35 width?
Last edited: