swynx
Active Member
- Joined
- Mar 26, 2008
- Messages
- 2,401
- Reaction score
- 9
- Points
- 38
- Age
- 31
- Location
- lewiston idaho
- Vehicle Year
- 1994
- Make / Model
- Mazda
- Engine Size
- 4.0
- Transmission
- Manual
wasnt sure where to put this, thought about putting it in the rbv axles section, but wasnt sure.
so i replaced all 3 u joints in the dana 35 with some "heavy duty, greasable" type from oreilly's, im not sure if they were master pro, or precision or what. usually they hand me masterpro, and i think thats what they were.
any ways any one know if this is the same standard 297, if so whats so heavy duty? how does it compare to the 760?
i have a 33's and an aussie, with the c clip eliminator in the front and i havent had any issues yet, but was just looking for more info on these u joints. i do regrease them after every trip so they dont get driven more then 300 miles between greasing.
as far as i have read you either get a 297 or a 760.
so i replaced all 3 u joints in the dana 35 with some "heavy duty, greasable" type from oreilly's, im not sure if they were master pro, or precision or what. usually they hand me masterpro, and i think thats what they were.
any ways any one know if this is the same standard 297, if so whats so heavy duty? how does it compare to the 760?
i have a 33's and an aussie, with the c clip eliminator in the front and i havent had any issues yet, but was just looking for more info on these u joints. i do regrease them after every trip so they dont get driven more then 300 miles between greasing.
as far as i have read you either get a 297 or a 760.