bfro88
New Member
- Joined
- Nov 20, 2011
- Messages
- 3
- Reaction score
- 0
- Points
- 0
- Location
- fallbrook CA
- Vehicle Year
- 1996
- Make / Model
- Mazda
- Engine Size
- 3.0
- Transmission
- Manual
I am new to this, so bear with me here. I recently bought a 1996 mazda b3000 as my first car, just to come home and notice the bed is crooked. The left side was about 2 inches lower than the right. I figured it was the leaf springs because the right stack had 4 and the other had 3. Well i went to the junk yard, got some "new" leaf springs, installed them and also did a shackle flip in the process to level it out (painnn in the assss). Anyyyywayyys, it lowered it and it looks a whole lot better. But the problem is, ITS STILL CROOKED!! by two inches.. I am stumped on what to do.. it looks really bad and bothers me every time i see it. Should i flip the left shackle back to how it was to compensate? or is that ghetto af? if it is the bed bushings how do i replace those? can i just slide some washers in there?
Attachments
-
70.4 KB Views: 807