dashhho
Active Member
- Joined
- Sep 12, 2020
- Messages
- 125
- Reaction score
- 51
- Points
- 28
- Location
- Canada
- Vehicle Year
- 2005
- Make / Model
- Mazda B4000 SE
- Engine Type
- 4.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
I installed a headunit+amp and the sound comes through ok but when there is no sound on there is an pretty loud static 'whitenoise' sound. Even with volume set to the lowest it can be on the headunit.
I am running RCA's from the headunit to the amp for signal. I used the amp on a previous vehicle and it workes. When I turn on the LPF the whitenoise is gone - so I am thinking this clears the AMP?
Does this sound like an issue with interference from my cables being run too close to each other? The RCAs are bundled with the front speaker wires till they get to the back of the cab.
Any ideas for how to trouble shoot this?
I am running RCA's from the headunit to the amp for signal. I used the amp on a previous vehicle and it workes. When I turn on the LPF the whitenoise is gone - so I am thinking this clears the AMP?
Does this sound like an issue with interference from my cables being run too close to each other? The RCAs are bundled with the front speaker wires till they get to the back of the cab.
Any ideas for how to trouble shoot this?